Getting a lot of work done on the cuddy cabin

I have been working on the cuddy cabin.  Having a self leveling laser has been extremely helpful in this boat build.  I have used it for numerous purposes, most recently for finding and marking the height of the bunks all around the inside of the cuddy cabin, and for marking the cut off line on the cuddy cabin sides.  I highly recommend one!

 First up after getting the front collision chamber built it the front cuddy bulkhead.  I wanted the bulkhead to be angled back at the correct angle, so I build these blocks out of plywood to hold it at the right angle.

 Here is the bulkhead after fitting, cutting and gluing in place.

 Here it is about to get a little fiberglass tape.

I also installed the blocking under the deck for the aft cuddy bulkhead.  I had some leftover 1-1/4" plywood leftover from making the shelves, so this worked perfect.  I made a template from cardboard, cut them out and glued them in.

I also installed some fiberglass drain tubes that I plan to leave a drain plug in them at all times.  The only reason they will drain is if water somehow gets in the front cuddy, or if I have to wash it out.

Next up is building the aft cuddy bulkhead.  This was easier than I thought.  I took several measurements using a laser "tape measure".  Then I transfered the marks and the correct angles to a sheet of plywood and cut it out.  I was almost a perfect fit the first try.

Then I filled and taped all the seams and reinforced the area around the bottom of the door.

 Here you can see the doubler that I made as well.  Instead of making this and installing seperately, I just attached it to the bulkhead and installed it as one piece.

Now it was time to start building the cuddy bunks, but first I have to put down a floor in the cuddy cabin.  Making the template was once again easy with the laser level and a tape measure.  I used the laser to shoot a level horizontal line where I wanted the floor to be and traced it out with a Sharpie.  Then I took a bunch of measurements and cut out a floor from plywood.  I glassed both sides of the floor.

I also wanted to make a drop in to use the small storage area under the cuddy floor.  Here is a closeup of the drop in floor panel.

I used some heavy 12 ounce woven roving for the topside to allow some non-skid effect.
I epoxied the floor in place with a heavy fillet around the edge and then taped it in.  Very solid and sturdy.

 I did not put a stringer under the deck because it is rock solid without it.  If I need one, I will put one in.

Making the bunks was very straightforward.  I used a straight piece of plywood and glued it in.  Then I installed some blocking to support the top of the bunks.

 I also painted the inside of the bunks and under the cuddy deck.  Now or never!  I am using Glidden Poly Porch paint for most of this type of painting.  Great paint.

Finally I made the bunk tops.  I made a template out of cardboard, then cut them out of plywood.  I also added two drop ins on each bunk to allow storage underneath.  I did not install them yet, but they are ready.

Next up is to install the cuddy sides, and roof.  Hope to get this done this week.